Root irrigation kit with 2 angled drippers, 2.2 l/h, PE hose 50 cm, DSK-3222L
Two drippers, 2.2 l/h with inlet, PE hose 50 cm, SET - a set for precise watering of plants. Typically used when growing plants in pots and hydroponic systems placed under cover. Also widely used in plantations and nurseries of trees and shrubs grown in soil. The set consists of an injector, PE tube and a drip stick.
A flexible polyethylene hose 50 cm long allows you to accurately supply water to any plant, regardless of its location. The drip wand is equipped with an inlet labyrinth, which ensures a turbulent flow and uniform distribution of water at all points connected to the same supply line.
At a pressure of 1 bar, the emitter has a water flow rate of 2.2 l/h. The dripper is installed directly near the root collar of the plant.
ADVANTAGES- precise water supply directly to the root zone,
- plants can be watered regardless of the distance between them (thanks to a 50 cm long polyethylene hose),
- uniform water flow thanks to the labyrinth of turbulent flow,
- saving and optimal use of water,
- reduced risk of spreading fungal diseases (leaves remain dry),
- the possibility of simultaneous watering and fertilizing of plants,
- can be watered at any time of the day,
- easy installation and flexible adaptation to different types of cultivation (potted, hydroponic, soil).
- using white 3x5 mm PE pipes, which heat up more slowly than black ones, which helps maintain a more stable water temperature, especially when growing cover crops and in hot conditions.
Compatible with droppers:
DSE-PCD04
DSE-PCND04
DSE-TOD02
DSE-TOD04
Installation process:
1. System planning Decide where the plants will be placed and how many drippers you need.
2. Unfold and install the polyethylene pipe Unfold the polyethylene pipe along the planned irrigation line.
Secure it to the ground with pins or mounting brackets
Mark on the PE pipe (16/20/25 mm) where the hoses leading to the drippers will be connected.
3. make holes in the polyethylene pipe Using a special hole punch (DSA-3302L), make holes in the previously marked places.
Standard holes - 3 mm
4. Installing the kit into a polyethylene pipe Insert a compatible dropper (
from the list above ) into the hole in the polyethylene pipe - it should fit snugly to prevent leakage.
Screw the bipod to the dropper post
Drive a stick into the ground near the plant.
5. Closing the system Close the end of the polyethylene pipe with a plug or cap.
Connect a water source - for example, a tap, a tank with a pump, an automatic system.
6. Test and adjust Turn on the water and check that each dripper is working properly.
If necessary, adjust the length of the hoses or check the tightness of the connections.
If using valves, adjust the flow individually.
EAN: 5907544462125
